18 SERVICE WORK ON THE ENGINE
116
18.2
Checking the engine oil level
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
F03260-10
Condition
The engine is at operating temperature.
–
Check the engine oil level.
Info
After switching off the engine, wait one minute before
checking the level.
The engine oil is at a level between the lower edge
A
and
the middle of the level viewer
B
.
» If the engine oil is not up to the lower edge
A
of the level
viewer:
–
Add engine oil. (
18.3
Changing the engine oil and oil filter, cleaning the oil screen
Warning
Danger of scalding
Engine and gear oil get very hot when the motorcycle is ridden.
–
Wear suitable protective clothing and safety gloves.
–
In the event of scalding, rinse the area affected immediately with lukewarm water.
Note
Environmental hazard
Hazardous substances cause environmental damage.
–
Dispose of oils, grease, filters, fuel, cleaning agents, brake fluid, etc., correctly and in compliance with the appli-
cable regulations.
Info
Drain the engine oil with the engine at operating temperature.
Preparatory work
–
Park the motorcycle on a level surface.
F03263-10
Main work
–
Position an appropriate container under the engine.
–
Remove oil drain plug
1
with the magnet and seal ring.
Info
Do not remove screws
2
.
Summary of Contents for EC 350F
