When the gas flow is blocked, the detector will go into alarm and disable the
pump. Press the power/menu button to reactivate the pump.
Icon
Description
1
Alarm Condition
2
Pump Status
3
Calibration/Test Mode
4
Battery Indicator
5
Gas Readings
6
Gas Identifiers
6
5
1
3
2
4
READ FIRST BEFORE OPERATION
The Multi Gas Clip Pump
is a personal safety device designed to detect the
presence of hydrogen sulfide (H2S), carbon monoxide (CO), oxygen (O2) and
combustible gases (LEL). Before operation, ensure that you have been properly
trained on the use of the detector and the appropriate actions to take in the
event of an alarm condition.
Display Components
When a Gas Reading (5) exceeds its alarm threshold, the detector will go into
visual, vibrating and audible alarm. On the display, the icon will appear
beside the Alarm Condition (1) and the associated Gas Identifier (6) will flash
off and on continuously.
Warning
- Users must familiarize themselves with the icons in both
alarm and non-alarm states.
Warning
- If the display is missing icons, or cannot be clearly read,
discontinue use and contact Gas Clip Technologies.
Warning
-
The IR LEL sensor will not detect hydrogen (H2) or acetylene
(C2H2) gases however, due to their cross-sensitive nature, the CO sensor
will go into alarm well below 10% LEL.
Factory Default Alarms
Sensor
LOW
HIGH
TWA
STEL
H
2
S
10 ppm
15 ppm
10 ppm
15 ppm
CO
35 ppm
200 ppm
35 ppm
50 ppm
O
2
19.5%
23.5%
LEL
10%
20%
Turning On the Detector
To activate the detector, press and briefly hold down the power/menu button.
Activation tone will sound. Each Gas Identifier will show a chasing “0” for the
Gas Reading while it is stabilizing and self-testing. Once all Gas Identifiers
have completed the warm up and stabilization sequence, < 65 seconds, the
detector is ready to detect all applicable gases. Display will show:
Before each use, check that the gas inlet
and alarm port are clear of any debris or
obstructions.
Stabilizing
Fully operational
Manually Calibrating the Detector
Continuously hold down the power/menu button through the “OFF”
countdown and the “CAL” countdown that follows. During these countdowns,
the detector will beep and flash 8 times with a pause between countdowns.
Display will show:
(pause)
Release the power/menu button when the display shows “AUTO ZERO”
followed by “APPLY GAS”. Connect a hose from a demand flow regulator on a
gas cylinder to the detector's gas inlet and apply gas. Calibration is complete
once the detector goes into alarm and the next calibration due date is
displayed. Turn gas off and remove hose from regulator. Display will show:
(connect hose)
Note: Calibration can also be done using the MGC Pump Clip Dock.
To confirm that there are no leaks in the
sampling system, perform a blocked flow
test 1.) daily and 2.) any time the sampling
system is changed.
Turning Off the Detector
Press and hold down the power/menu button until the “OFF” countdown is
complete. During the countdown, the detector will beep and flash 4 times
then turn off. Display will show:
