Garwoods EC-2330, Installation & Operating Instructions Manual

Page: 4 / 24

3
2
、
Installation Guideline
★
Installation should be followed below requirements
：
1、
The walls on top of the working face and next to the installation of infrared cooker must
be heat-proof.
2、
The laminated boards and adhesive used for installation must be heat-resistant.
3、
For any installation method, the air under the cooker and behind the cooking range should
have enough space for cooling in order to ensure the safety of operating the infrared
cooker.
4、
Based on the prescribed dimensions, a square hole is opened on the work table. Ensure
the distance between any side of the work table and the walls is
≧
100mm.
5、
Protect the opening: If in contact with damp, the laminated boards used in marking the
work table will easily expand more. It is required to stick varnish or special adhesive onto
the edge of the opening in order to prevent any steam from condensation under the work
table.
6、
For any condition of installation, the infrared cooker should have a good ventilation
condition with air inlet and air outlet not blocked.
7、
Don’t place other equipment on the working face of the double cooking zones of the
infrared cooker and within the range of 30cm around the working face.
8、
If choosing a table-top installation, ventilation hole shall be at least 100mm from wall
surface.
9、
The infrared cooker must be complied with a 13A power outlet.
★
Steps on Installation
：
~ Open an installation hole on the worktop of cabinet as per
【
illustration 1
】
.
(Note : The height shall be more than 100mm)
Cut out dimensions(unit/mm)
：
(W) 670 x (D) 350 x (H) 100
【
illustration 1
】