25
ENGLISH
EN
Do not race when working with the appliance. Walk
slowly and cautiously.
Be careful when going backwards – risk of tripping!
Make sure your posture is safe, especially on slopes. Do
not cut on too steep slopes. Be particularly careful when
changing travelling direction on slopes.
On slopes always go straight to the slope and not up
and down.
Pay maximum attention when turning around and
pulling the appliance to you.
Switch the mower off whenever carrying or inclining it
or when being outside a grass area. Wait until all rotating
parts have stopped.
If an undesirable item is encountered or the appliance
starts vibrating, the appliance must be switched off and
the socket plug removed. Check whether the appliance
is not damaged. Repair any damage.
Switch the appliance immediately off after finishing
your work.
• Stop the machine and take out the contact key. Wait
until all rotating parts have stopped and the unit has
cooled down. Take out the key.whenever you leave
the lawnmower.
• To release a blocked blade.
• To adjust the mowing height.
• To empty the collection bag.
• Check the machine if working perfectly after catching
an undesirable object. Repairs must be executed
before putting the machine into operation again..
• To lift the machine or take it away..
• To flip the mower over or carry it (e.g. from lawn to
lawn or across a road).
• Clean the mower or do any other works before
checking the mower.
The ON/OFF switch and safety switch must not be
locked.
Use only those batteries for the power tool that have
been designed to be used for that tool. Use of other
batteries may lead to injuries and a risk of fire..
Avertissement: Cet outil électrique génère pendant
le fonctionnement un champ magnétique. Dans
certaines circonstances, ce champ peut perturber
le fonctionnement des implants médicaux actifs ou
passifs. Afin de réduire le risque de blessure graves
ou mortelles, nous recommandons aux personnes
portant un implant médical de consulter un médecin
et le fabricant de l‘implant médical avant l‘utilisation
de l‘appareil.
Do not use the device near flammable liquids or
gases. Risk of fire and explosion in case of short
circuit.
Work instructions
Accumulators are supplied partially charged and
must therefore be fully charged before being used for
the first time.
• Charge the accumulator when the appliance is
running slowly or stops.
• A li-ion battery may be charged at any time without
any shortening of its life. Charging process interrup-
tion will not damage the accumulator.
• A li-ion battery is protected by the Electronic Cell
Protection against deep discharge.
• A significantly shorter operating time of a charged
battery means the battery life is over and the batte-
ry must be replaced.
Maintenance
Rotating blade
Any works / adjusting on the machine to be only
performed with the engine switched off, contact
key taken out and when the mowing blade is not
moving.
Switch the appliance off and remove
the contact key before any adjustment,
cleaning and servicing work. Wait until all
rotating parts have stopped and the appli-
ance cooled down. After each use, clean
carefully the cutter bar. Wipe it with a cloth
moistened in oil or apply metal treatment
spray on it.
Summary of Contents for GM 330/20-4
Page 81: ...77...
