13
14
model no. 46-5681/46-5682
WO
Date
Artist
PROCESS
MAGENTA
PANTONE
287C
PROCESS
BLACK
PANTONE
000
PANTONE
000
PANTONE
000
11/08/13
01a
Brenda
638604
CTC Generic
815446
LITHO FLEXO
mm/dd/yy
02a
xxxxxx
mm/dd/yy
03a
xxxxxx
mm/dd/yy
04a
xxxxxx
mm/dd/yy
05a
xxxxxx
mm/dd/yy
06a
xxxxxx
mm/dd/yy
07a
xxxxxx
46_5681_46_5682
02a
11/26/13
Brenda
02b
11/29/13
Brenda
Simple Troubleshooting continued
Problem
Reason
Solution
The lock has been working
normally, but suddenly, the
latch bolt locks up, and the
turn piece inside cannot be
rotated, not even with
the key.
The detection of latch bolt
position is abnormal.
Please take out one
battery first, then press
any button on the
front panel for electric
discharge, and put the
battery back next. The
latch bolt will automatically
re-detect its position
subsequently.
The door can be locked
normally, but three short
beeps are heard and the
door cannot unlock when
the user code is entered
and the programming
button is pressed.
The functioning of the
micro-switch is abnormal.
Please unlock the door
with the keys first and then
contact the manufacturer
for inspection and
maintenance.
While the door is closed,
you hear the latch bolt
coming out when you
press the programming
button to lock the door;
however, three short beeps
are emitted. Conversely,
while the door is open, no
beeps are emitted when
locking the latch bolt.
(1) The depth of the latch
bolt hole is insufficient.
(2) The latch bolt is not
aimed at the opening of
the strike.
(1) Please dig the latch
bolt hole deeper for the
strike deeper (min. depth
of 2.5 cm).
(2) Please adjust the strike
to the appropriate position.
Simple T
roubleshooting
Attention
When the latch gets stuck frequently, please check if the opening
of the strike aims at the central position of the latch bolt, if the latch bolt can
stretch out freely, or if the hinges are deformed or tilted.
User Code & Function Set up
User Code & Function Set up
1. Leave door unlocked while programming.
2. Please run the door-handing identifying process (Refer to programming
table) before initial setup or once default settings are restored.
3. Please change default Programming Code (0000) and User Code (1234)
before initial setup.
4. LED flashes orange slowly while programming. LED flashes green twice
with 2 long beeps when code is entered correctly. LED flashes red
3 times with 3 beeps when code has been entered incorrectly,
(You need to wait for 6 seconds or press programming button when
incorrect input, then re-program the system again.)
5. Every programming step should be done within 6 seconds.
6. You can lock/unlock this product by either key or keypad. Please refer
to the following programming table for function set up.
046-5681-0 to 046-5681-8 & 046-7244-0 to 046-7246-6