Magnum 6K16V Managed Fiber Switch Installation and User Guide (06/04)
Step 3. Remove front panel face plate retaining screws
There are two PM slots (A, B) located on the front of the chassis cover. Looking into the
vertical placed Chassis cover of the unit, there are three brackets with retaining screws
(#256 flat head ) which hold each PM Face plate card slot securely. These six screws
shown in the picture below are used to secure a PM face plate in position, but unscrew
only four of the screws as shown in Fig. below. These screws are also used to secure the
individual 6KPM cards screen plate which can be subjected to significant forces from the
attached cables. (See Figure 3.6.1c)
Figure 3.6.1c: Top View – 6KPM retaining screws hold Face Plate
3.6.2
Installing 6KPM Cards in the Magnum 6K16V
Up to two front-mounted 6KPM cards may be installed in one Magnum 6K16V
Managed Fiber Switch unit. Follow these steps to install a 6KPM.
Step 1.
Remove top chassis cover. See procedure in Section 3.6.1 above.
Step 2.
Placed
Granddaughter board (as shown in fig. 3.6.2a and 3.6.2b) on the chassis
built in stand off (female) provided at the front of the 6K16V Main Board and
screw down tightly with the three 5/16 stand-off (male) on the top of the
Granddaughter board The 5/16 stand off has been used to place the daughter
board on the top of the granddaughter board and latch it securely.
Fig 3.6.2a Granddaughter Board shown separately
27
www GarrettCom com
.
.
