15
MAGNASCANNER PD 6500
OWNER’S MANUAL
©2000 GARRETT METAL DETECTORS, INC.
6/19/00
PN 1531100
5.6
TONE
(
TONE 5
)
A total of nine tone levels can be accessed using the + or – touchpads. A number cor-
responding to the tone selection appears on the LCD.
Press
ACCESS
for next adjustment or
OPERATE
to resume normal operation.
5.7.
CHANNEL
(
CHANNEL 1
)
This feature enables multiple walk-through metal detectors to operate simultaneously in
proximity. Use Channels 1 and 2 when two PD 6500s are operating near each other. In
cases where three or more PD 6500s are operating near each other, use Channels 1, 2
and 3 respectively and then repeat the channel sequence on any additional walk-
throughs. (See Section 11.3.) Use channels A,B,C,D when operating with CS 5000.
Press
ACCESS
for the next adjustment or
OPERATE
to resume normal operation.
5.8.
VIDEO FILTER
(
VIDEO FILTER 1
)
A video filter enables the PD 6500 to operate effectively in proximity to a variety of
video terminals, including x-ray monitors, computers and closed circuit televisions. Use
the
+
and – touchpads to select from 63 filter settings. If you observe noise at the
desired base sensitivity setting, increment the video filter to the setting with the least
amount of interference as shown by the bar graph.
Press
ACCESS
for next adjustment or
OPERATE
to resume normal operation.
5.9.
SYNCHRONIZATION
(
SYNC MASTER
)
Synchronization is factory preset to
MASTER
. Refer to Section 11.3 for a more detailed
explanation of synchronization.
SYNC MASTER,
provides the PD 6500 with a self-generated synchronization from the
power line.
SYNC SLAVE,
synchronizes the PD 6500 from a second signal on the sync terminal
located on the left edge of the transmitter controller board.
Press
ACCESS
for the next adjustment or
OPERATE
to resume normal operation.
5.10.
RELAY
(
RELAY N/C
)
This feature enables you to change the AC and DC relay circuits to “normally open”
(
RELAY N/O
) or “normally closed” (
RELAY N/C)
depending on the installation require-
ments. Use the
+
and – touchpads to make a selection.
Press
ACCESS
for next adjustment or
OPERATE
to resume normal operation.
