background image

Never put batteries in mouth. If swallowed, contact your 

physician or local poison control center.
Replaceable coin cell batteries may contain perchlorate 

material. Special handling may apply. See 

www.dtsc.ca.gov

/hazardouswaste/perchlorate

.

 CAUTION

Contact your local waste disposal department to properly 

recycle the batteries.

Before you can replace the battery, you must have a small 

Phillips screwdriver, a small flat screwdriver, and a CR2032 

lithium coin-cell battery.

1

Using a Phillips screwdriver, remove the three screws from 

the back plate  .

2

Remove the back plate from the remote.

3

Wrap the end of a small flat screwdriver with tape.
The tape protects the battery, battery compartment, and 

contacts from damage.

4

Carefully pry the battery from the back plate.

5

Install the new battery into the back plate with the positive 

side facing down.

6

Verify the gasket   is fully seated in the groove.

7

Replace the backplate, aligning the post   with the gap in 

the circuit board  .

8

Replace and tighten the three screws.

NOTE: 

Do not overtighten.

Device Information

Specifications

Headlight Specifications

Battery type

Rechargeable, built-in lithium-ion battery

Battery life

Up to 2.5 hr. in high mode
Up to 5 hr. in flash mode
Flash mode is available on the Varia HL 
500 only

Operating temperature 
range

From -15° to 50°C (from 5° to 122°F)

Charging temperature 
range

From 0º to 40ºC (from 32º to 104ºF)

Radio frequency/protocol

2.4 GHz ANT+ wireless communications 
protocol

Water rating

IEC 60529 IPX7

1

Varia HL 500 LED luminous 
flux and peak illuminance

600 lm
95 lx

Varia HL 501 LED luminous 
flux and peak illuminance

300 lm
65 lx

Headlight Light Intensity Modes

Intensity 
Mode

Varia HL 500 Illuminance 
and Luminous Flux

Varia HL 501 
Illuminance and 
Luminous Flux

Overdrive

600 lm
95 lx

Not applicable

High

400 lm
70 lx

300 lm
65 lx

Medium

250 lm
50 lx

200 lm
50 lx

Low

150 lm
30 lx

150 lm
35 lx

Flashing

600 lm
95 lx

Not applicable

Taillight Specifications

Battery type

Rechargeable, built-in lithium-ion battery

Battery life

Up to 4 hr. in high mode
Up to 14 hr. in flash mode
Flash mode is available on the Varia TL 300 
only

Operating temperature 
range

From -15° to 50°C (from 5° to 122°F)

Charging temperature 
range

From 0º to 40ºC (from 32º to 104ºF)

Radio frequency/
protocol

2.4 GHz ANT+ wireless communications 
protocol

Water rating

IEC 60529 IPX7

1

Varia TL 300, 301 LED 
luminous flux

22 lm (typical in high mode)

Taillight Light Intensity Modes

Intensity Mode Varia TL 300 Luminous 

Flux

Varia TL 301 Luminous 
Flux

High

22 lm

22 lm

Medium

14 lm

Not applicable

Low

7 lm

14 lm

Flashing

28 lm

Not applicable

Braking

35 lm

35 lm

Remote Specifications

Battery type

User-replaceable CR2032, 3 V

Battery life

Up to 1.5 yr. at 1 hr./day

Operating temperature 
range

From -10° to 50°C (from 14° to 122°F)

Radio frequency/protocol 2.4 GHz ANT+ wireless communications 

protocol

Water rating

5 ATM

2

The device withstands incidental exposure to water of up to 1 m for up to 30 min. 

For more information, go to 

www.garmin.com/waterrating

.

The device withstands pressure equivalent to a depth of 50 m. For more 

information, go to 

www.garmin.com/waterrating

.

Device Information

5

Summary of Contents for Varia HL













Reviews: