background image

Maintenance

Cleaning the Transducer

Aquatic fouling accumulates quickly and can reduce your 

device's performance.

1

Remove the fouling with a soft cloth and mild detergent.

2

If the fouling is severe, use a scouring pad or putty knife to 

remove growth.

3

Wipe the device dry.

Specifications

Specification

Measurement

Dimensions (W x H x L)

32 x 118 x 96 mm (1.3 x 4.6 x 3.8 in.)

Transducer weight

380 g (0.84 lb.)

Total weight (transducer, mount, 
and cable)

840 g (1.85 lb.)

Max. continuous power usage

8 W

Peak transmit power

48 W

Operating voltage

From 10 to 35 Vdc

Operating temperature range*

From 0 to 40°C (from 32 to 104°F)

Storage temperature range

From -40 to 70°C (from -40 to 158°F)

Material

ASA plastic

Maximum range**

91.4 m (300 ft.)

Frequency

417 kHz

Fuse rating

4.0 A mini 32 Vdc

* When the transducer is used out of the water, the transducer 

monitors the internal temperature and suspends operation until 

the temperature returns to the operating range.
**Dependent upon transducer placement, water salinity, bottom 

type, and other water conditions.

© 2017 Garmin Ltd. or its subsidiaries
Garmin

®

 and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, 

registered in the USA and other countries. Panoptix

 is a trademark of Garmin Ltd. or its 

subsidiaries. These trademarks may not be used without the express permission of 
Garmin.

Summary of Contents for Panoptix PS22-TR

Page 1: ...e software you must obtain a software update memory card or load the latest software onto a memory card 1 Turn on the chartplotter 2 After the home screen appears insert the memory card into the card slot NOTE In order for the software update instructions to appear the device must be fully booted before the card is inserted 3 Follow the on screen instructions 4 Wait several minutes while the softw...

Page 2: ...motor shaft Installing the Transducer on the Trolling Motor Shaft Mount NOTICE You must secure the transducer cable to the shaft or other secure location during installation Damage to the transducer cable wire or the cable jacket can cause transducer failure You should mount the transducer as far from the motor as possible Placing the transducer too close to the motor can prevent proper compass ca...

Page 3: ... cable to a 10 to 35 Vdc power source and to the groundInstallation Diagram page 3 NOTE A power switch is optional The chartplotter automatically turns the transducer on and off 3 Select an option Connect the network cable to the network or the Panoptix port on your chartplotter Connect the network cable to a port on the GMS 10 if available Cable Routing Grommets When routing cables through your b...

Page 4: ...ing temperature range From 0 to 40 C from 32 to 104 F Storage temperature range From 40 to 70 C from 40 to 158 F Material ASA plastic Maximum range 91 4 m 300 ft Frequency 417 kHz Fuse rating 4 0 A mini 32 Vdc When the transducer is used out of the water the transducer monitors the internal temperature and suspends operation until the temperature returns to the operating range Dependent upon trans...

Reviews: