Garmin GXM 54 Installation Instructions Manual Download Page 9

Acknowledgment

Garmin SHALL HAVE NO LIABILITY IF CHANGES IN THE SERVICE PROVIDER'S SUBSCRIPTION OFFERING 
NEGATIVELY IMPACTS OR RENDERS IMPOSSIBLE THE USE OF PURCHASED Garmin HARDWARE EQUIPMENT 
WITH THE SERVICE PROVIDER'S OFFERING IN THE FUTURE.
THE USER AGREES THAT THE SiriusXM WEATHER SERVICE OFFERING IS PROVIDED "AS IS", THAT YOUR 
Garmin HARDWARE EQUIPMENT ONLY ALLOWS THE DISPLAY OF SUCH SERVICE OFFERING, AND THAT ANY 
CHANGES BY THE SERVICE PROVIDER MAY INTERFERE WITH THE ABILITY OF YOUR Garmin HARDWARE 
EQUIPMENT TO RECEIVE OR DISPLAY SUCH SERVICE OFFERING. FURTHER, SUCH SERVICE OFFERING 
CONTAINS INFORMATION FURNISHED BY OTHERS WHO ARE NOT UNDER THE CONTROL OF Garmin, AND 
THEREFORE THE SERVICE OFFERING IS ACCORDINGLY FURNISHED WITHOUT ANY WARRANTY OF Garmin, 
EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION, IMPLIED WARRANTIES OF MERCHANTABILITY AND 
FITNESS FOR A PARTICULAR PURPOSE.

FCC Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this 
device may not cause harmful interference, and (2) this device must accept any interference received, including 
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant 
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy 
and may cause harmful interference to radio communications if not installed and used in accordance with the 
instructions. However, there is no guarantee that interference will not occur in a particular installation. If this 
equipment does cause harmful interference to radio or television reception, which can be determined by turning 
the equipment off and on, the user is encouraged to try to correct the interference by one of the following 
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet that is on a different circuit from the GPS device.
• Consult the dealer or an experienced radio/TV technician for help.
This product does not contain any user-serviceable parts. Repairs should only be made by an authorized Garmin 
service center. Unauthorized repairs or modifications could result in permanent damage to the equipment, and 
void your warranty and your authority to operate this device under Part 15 regulations.

Innovation, Science and Economic Development Canada Compliance

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and 
Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: 
(1) this device may not cause interference, and (2) this device must accept any interference, including 
interference that may cause undesired operation of the device.

Limited Warranty

The Garmin standard limited warranty applies to this accessory. For more information, go to 

www.garmin.com

/support/warranty

.

© 2019 Garmin Ltd. or its subsidiaries
Garmin

®

 and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. GXM

 is a trademark of Garmin Ltd. or its 

subsidiaries. These trademarks may not be used without the express permission of Garmin.
SiriusXM

®

 is a registered trademark of SiriusXM Radio Inc.

Apple

®

 is a trademark of Apple Inc., registered in the U.S. and other countries. Android

 is a trademark of Google

 Inc. Wi

Fi

®

 is a registered mark of Wi-Fi Alliance 

Corporation. Windows

®

 is a registered trademark of Microsoft Corporation in the United States and other countries.

All other trademarks and copyrights are the property of their respective owners.
This product may include open source software. This source, and modifications thereto, may be freely found at 

developer.garmin.com

.

9

Summary of Contents for GXM 54











Reviews: