GTX 327 MAINTENANCE MANUAL
Page 4-7
190-00187-05
Rev. B
4.4.5
Display Assembly (Figure 7-1)
1.
Carefully place the clean lens (2) on the bezel assembly (1) with the stepped edge seated securely in
the bezel and the black frame facing rearward.
2.
Place the display assembly (3) into the retaining tabs on the bezel assembly and carefully insert the
display assembly connector over the bezel assembly pins.
3.
Secure the display assembly to the bezel assembly with two screws (12).
4.4.6
Front Panel Assembly (Figure 7-1)
1.
If the front panel display assembly has been removed from the bezel for any reason, reinstall as
described in paragraph 4.4.5.
2.
Carefully place the front panel assembly (1) on the unit. Attach to the unit using two screws (12) in
the top holes in the bezel.
3.
Install the flexible circuit cable (9) as described in paragraph 4.4.7.
4.4.7
Flexible Circuit Cables (Figure 7-3)
CAUTION
Orientation of the blue strain relief band on the cable is important. When
inserted into the connectors the blue bands must face toward the brown retaining
lip of the connector.
1.
With the retaining lip of the ZIF connectors lifted, carefully insert the flexible circuit cable (9) into
the main board (4) and front panel ZIF connectors.
2.
While gently holding the flexible circuit cable in the connector, press down on the connector lip to
secure the cables in place.
3.
Ensure that cable bend orientation is as close to original as possible.
4.
When installing the ribbon cable (10) carefully insert the ribbon cable connector observing key
orientation and without offsetting the pins.
The document reference is online, please check the correspondence between the online documentation and the printed version.