190-01007-01
GTN 725/750 Maintenance Manual
Rev. 5
Page 5-10
5.8 Internal Datacard Removal and Replacement
Refer to figure 5-9 when performing the following steps.
To remove the datacard:
1. Peel off the aluminum foil label that is covering the datacard slot.
2. Take the tip of a demagnetized #1 flat-tip screwdriver, or equivalent tool, and use it to lightly press
on the datacard. This releases the card.
To replace the datacard:
1.
Insert the new datacard (P/N 011-02512-01) into the datacard slot, press until seated.
2.
Apply a new aluminum foil label (P/N 249-00211-02) to cover the datacard slot.
Figure 5-9 Internal Datacard Access Slot
Aluminum Foil Label
Covering
%BUBD
ard Slot
