GTN 625/635/650 TSO Installation Manual
Page 6-9
190-01004-02
Rev. C
GTN
Selection
GNS Equivalent
Description
Lightning Detector 1
WX-500
Serial communication to an L3 Communications WX-500
Stormscope.
MapMX
MapMX
Serial position, altitude, velocity, and navigation data.
Panel GTX w/TIS #1
N/A
Select this format for the GTX 330/330ES transponder #1. This
provides ground speed, GPS PVT, and pressure altitude
information to the transponder.
Panel GTX w/TIS #2
N/A
Select this format for the GTX 330/330ES transponder #2. This
provides ground speed, GPS PVT, and pressure altitude
information to the transponder.
6.6.3
HSDB (Ethernet) Configuration Page
Access the HSDB Ethernet page, as shown in Figure 6-6,
by touching the ‗HDSB (Ethernet)‘ key on the GTN Setup
page. Touch the key next to the port to configure it as
‗Connected‘ or ‗Not Connected‘. If a Garmin LRU is
connected to a specific Ethernet port, then configure the
port as ‗Connected‘. If no LRU is connected to the port,
configure it as ‗Not Connected.‘
6.6.4
Interfaced Equipment Page
Access the Interfaced Equipment page, as shown in
Figure 6-7, by touching the ‗Interfaced Equipment‘ key
on the GTN Setup page. This page allows the
configuration of the presence of a cross-side navigator,
GDL 69/69A, Transponder #1 and Transponder #2.
Figure 6-6. HSDB Port Utilization Page
Figure 6-7. Interfaced Equipment Page
