Garmin GPSMAP 190-01230-10, Owner'S Manual

Page: 57 / 84

GPSMAP 400/500 Series Owner’s Manual 5
Configuring the Chartplotter
2. Select a setting ( Sounder , Route , System , or Garmin ).
3. Select the NMEA 0183 output sentence to toggle the output on or
off.
Posn. Precision —adjust the number of digits ( Two digits ,
Three digits , or four digits ) to the right of the decimal point
for transmission of NMEA output.
waypoint ids —determine how the unit identifies waypoint
identifiers (
Names
or
Numbers
).
defaults —resets all NMEA 0183 sentences to the default setting.
NMEa 2000 Setup —
device List —lists the NMEA 2000 devices on your network. If a
NMEA 2000 device has configuration options or settings, select
the device for a list of options.
Label devices —allows you to name your engines and tanks so
that you can better identify their location on the boat.
To label engines as numbers:
From the Home screen, select Configure > Communications >
NMEA 2000 Setup > Label Devices > Change Engine Labels
> Use Numbers .
•
•
•
•
•
To label engines as names:
1. From the Home screen, select Configure > Communications >
NMEA 2000 Setup > Label Devices > Change Engine Labels
> Label Type > Choose Names .
2. Select the engine you want to name.
3. Select the location of the engine:
Port (P) , Center (C) ,
Starboard (S) , Fore (F) , or Aft (A) .
4. Select the label you want to use for the engine.
To label tanks as numbers:
1. From the Home screen, select Configure > Communications >
NMEA 2000 Setup > Label Devices > Change Tank Labels .
2. Select the type of tank you want to label.
3. Select
Use Numbers .
To label tanks as names:
1. From the Home screen, select Configure > Communications >
NMEA 2000 Setup > Label Devices > Change Tank Labels .
2. Select the type of tank you want to label.
3. Select
Choose Names .
4. Select a tank.
3. Select the location of the tank:
Port (P) , Center (C) , Starboard
(S) , Fore (F) , or Aft (A) .
4. Select the label you want to use for the tank.