190-02081-03
GFC 600H HFCS Part 27 STC Maintenance Manual
Rev. 3
Page 7-21
7.8 GFC 600H System Configuration
Configure the GFC 600H FCS (and all interfaced units) to the original configuration settings that are
retained with the rotorcraft permanent records (Appendix A). Each configuration item is saved to the
configuration module as it is made. When the configuration item is selected by pressing the
VS
button to
accept the value, the new value is stored in the configuration module at that time.
Refer to Section 3.3 for a description of the GMC 605H Configuration mode and how to navigate the
different pages/settings. To exit Configuration mode, cycle power to the GFC 600H system.
NOTE
Only the
SYS ' INSTALL
,
GMC DSP
,
RMT DSP
, and
GFC ' CALIBRATE
configuration
pages are used for configuring the GMC 605H and GFS 83 (refer to Section 3.3 for page
layout). All other pages displayed while in Configuration mode provide system
information that is useful for maintenance and troubleshooting.