190-01717-B1
G500/G600 TXi Part 23 AML STC Maintenance Manual
Rev. 1
Page 2-3
2.1.4
Entering Configuration Mode
The configuration mode of the GDU 1060/700 can be accessed by holding down the inner knob located at
the bottom right of the unit as shown in Figure 2-1 upon initial power up. The knob must be pressed until
the splash screen shown in Figure 2-1 disappears and the configuration menu appears
.
Figure 2-1 Entering the configuration mode on the GDU
2.1.5
SD Card Location Options
The GDU 1060/700 has two SD card slots that can be used for various tasks. The following list describes
what tasks can be performed from which SD card slot:
•
Either Slot
◦
Installer Unlock
◦
Feature Enablement
◦
Screenshots (If a card is present in both slots the screenshot will print to the top slot only)
◦
Update databases
•
Top/Left Slot Only
◦
Software updates
◦
GSU/GRS Log Downloads
◦
Flight Log Download
◦
Save configuration to SD card
◦
Save error log to SD card
◦
Load configuration from SD card
•
Bottom/Right Slot
◦
Update Databases (faster)
