Garmin G1000 Series, Pilot'S Manual

Page: 34 / 338

Garmin G1000 Pilot’s Guide for the Diamond DA40
190-00592-00 Rev. A 2-6
PRIMARY FLIGHT DISPLAY
• CDI – Changes navigation mode on the CDI to
GPS, NAV1, or NAV2
• ADF/DME (optional; may appear as ADF , DME ,
or ADF/DME depending on the installation)
– Displays ADF/DME Radio Tuning Window
• OBS
– Selects OBS mode on the CDI when navi-
gating by GPS (only available with active leg)
• XPDR – Displays transponder mode selection
softkeys:
STBY – Selects standby mode (transponder does
not reply to any interrogations
ON
– Selects Mode A (transponder replies to
interrogations)
ALT – Selects Mode C - altitude reporting mode
(transponder replies to identification and
altitude interrogations)
VFR – Automatically enters the VFR code (1200
in the U.S.A. only)
CODE – Displays transponder code selection
softkeys 0-7
0 through 7 – Use numbers to enter code
IDENT – Provides special aircraft position
identification to Air Traffic Control (ATC)
BKSP – Removes numbers entered one by one
BACK – Returns to previous level softkeys
IDENT – Provides special aircraft position identi-
fication to ATC
BACK
– Returns to previous level softkeys
• IDENT – Provides special aircraft position identi-
fication to ATC
• TMR/REF – Displays Timer/References Window
• NRST – Displays Nearest Airports Window
• ALERTS – Displays Alerts Window