5 Using a 5 mm (
7
/
32
in.) flat (slotted) screwdriver, connect the power (+) wire to the PWR terminal on the
power connection block.
6 Route a 20 AWG (0.5 through 0.75 mm
2
) marine-grade, fully-tinned copper remote-on wire (not included)
from the amplifier to the AMPLIFIER ON wire on the stereo.
NOTE: The amplifier and the stereo must connect to a common ground location for the AMPLIFIER ON
signal to function properly.
7 Using a 4 mm (
5
/
32
in.) flat (slotted) screwdriver, connect the remote-on wire to the REM terminal on the
power connection block.
NOTICE
You should wait to connect the power terminal block to the amplifier. Make all of the other connections to the
stereo and speakers before completing the connection to power (
Completing the Connections, page 15
).
10
Fusion Apollo Multichannel Amplifiers Installation Instructions Installation Instructions