3
Using a 3 mm hex bit or wrench, remove the four screws
that secure the two brackets to the mount on both sides of
the cable channel.
4
Pull the power cable out of the channel along the side of the
mount.
5
Pull the transducer cable out of the channel along the side of
the mount.
Routing the Power and Transducer Cables Through the
Mount
After you have installed a replacement power cable, transducer,
or shaft, you should route the power and transducer cables
through the mount.
NOTICE
To avoid damaging the power and transducer cables when
deploying and stowing the trolling motor and to avoid
interference with the GPS and heading sensors in the motor,
you must route the cables through the right (starboard) side of
the mount and secure them using the included hardware. You
must not route the power cable through the left (port) side of the
mount, and it is not possible to install the included brackets on
the left (port) side. The left (port) side is reserved for additional
accessories or transducer cables that you may install in the
future.
1
Measure approximately 40 cm (16 in.) on the power cable
from where it connects to the steering servo housing, and
look for the mark on the cable applied at the factory.
2
If you do not see a mark on the cable, or if the mark is not
approximately 40 cm (16 in.) from the connection, make a
mark with a marker or tape.
3
With the motor in the deployed position, route the transducer
cable through the channel along the right (starboard) side of
the mount .
TIP:
To determine the right (starboard) side of the mount,
stand in a location where you can read the information on the
display panel.
4
Route the power cable through the channel above the
transducer cable.
5
Using the pull cable, carefully lift the motor from the deployed
position to the stowed position.
NOTICE
You must secure the cables to the mount with the motor in
the stowed position. If you complete this procedure with the
motor in the deployed position, the cables are not at their fully
extended length, and the added stress may damage the
cables during use.
6
Leaving a rounded bend in the cables , hold them against
the side of the mount where they enter the channel.
7
At the marked location on the power cable, place one of the
brackets that has two screw holes over the cables and
against the mount, aligning the holes on the bracket with the
holes on the mount.
8
Using a 3 mm hex bit or wrench, secure the bracket to the
mount using two screws .
9
Hold the cables against the bottom of the mount where they
exit the channel.
10
Place the other bracket that has two screw holes over the
cables and against the mount, aligning the holes on the
bracket with the holes on the mount.
11
Using a 3 mm hex bit or wrench, secure the bracket to the
mount using two screws .
12
Hold the cables against the plastic portion of the mount base,
close to the boat deck.
13
Insert the lower tab on the remaining bracket into a slot below
the cables , and rotate the bracket toward the mount base
to hold the cables.
10
