1
Using a Phillips screwdriver, remove the three screws from
the back plate .
2
Remove the back plate from the remote.
3
Wrap the end of a small flat screwdriver with tape.
The tape protects the battery, battery compartment, and
contacts from damage.
4
Carefully pry the battery from the back plate.
5
Install the new battery into the back plate with the positive
side facing down.
6
Verify the gasket is fully seated in the groove.
7
Replace the backplate, aligning the post with the gap in
the circuit board .
8
Replace and tighten the three screws.
NOTE:
Do not overtighten.
Specifications
Battery type
User-replaceable CR2032, 3 volts
Battery life
Up to 1.5 years (1 hour per day)
Operating temperature
range
From -10° to 50°C (from 14° to 122°F)
Radio frequency/protocol 2.4 GHz ANT+ wireless communications
protocol
Water rating
5 ATM*
*The device withstands pressure equivalent to a depth of 50 m.
For more information, go to
© 2014 Garmin Ltd. or its subsidiaries
Garmin
®
, the Garmin logo, and Edge
®
are trademarks of Garmin Ltd. or its subsidiaries,
registered in the USA and other countries. ANT+
®
is a trademark of Garmin Ltd. or its
subsidiaries. These trademarks may not be used without the express permission of
Garmin.
This product is ANT+
®
for a list of compatible
products and apps.
support.garmin.com
TA-2013/2179
