Setting Up the Power-Pole Anchor
Before you can use the chartplotter to control the Power-Pole anchor, you must select the required installation
mode.
The default initial installation mode setting is None. While the installation mode is set to None, the chartplotter
control of the Power-Pole anchor(s) is inactive.
1 From the Power-Pole toolbar, select
> Installation.
2 Select the installation mode that matches the anchor installation on the boat.
• To control a single port side Power-Pole anchor, select Port .
• To control a single starboard side Power-Pole anchor, select Starboard.
• To control dual Power-Pole anchors, select Dual.
3 Use the slider to set the desired speed for the anchor to deploy and retract.
Power-Pole Overlay
Before you can control the Power-Pole anchor with the chartplotter, you must enable the overlay (
) and set the Power-Pole installation mode (
).
The layout of the overlay varies based on the installation mode. Refer to your Power-Pole documentation for
more information.
Select to control both anchors simultaneously
Deselect to control the anchors independently
Select to fully retract the anchor
Select to fully extend the anchor
Hold to retract the anchor manually
Release to stop the anchor
Hold to extend the anchor manually
Release to stop the anchor
Select to open the menu
Select to enable the advanced boat control feature
NOTE: This option is available only when connected to a compatible Garmin trolling motor
PORT Port side anchor control buttons
STBD Starboard side anchor control buttons
110
Controlling Third-Party Equipment Installed on Your Boat
