2
Remove the mount base from the mounting surface, and use
a 3.2 mm (1/8 in.) drill bit to drill pilot holes in the two
locations you marked.
NOTICE
If you are drilling into a fiberglass surface, you may need to
use a specialized drill bit or drill counter-clockwise to avoid
damaging the fiberglass. For more information, contact your
vehicle manufacturer or a professional installer.
3
Apply waterproofing sealant around the drilled pilot holes,
and all the way around the edge of the back surface of the
mount base, where it will contact the vehicle.
You must use an outdoor waterproofing sealant that will bond
with your vehicle's exterior surface and not damage it. For
more information, contact your vehicle manufacturer or a
professional installer.
4
Place the mount base against the surface, aligning the
mounting holes in the base with the drilled pilot holes.
5
Fasten the mount base to the vehicle using two M4 screws.
NOTE:
The included screws are intended for installation on a
camper with a fiberglass shell. You must verify the screws
are the correct length and appropriate for the exterior
mounting surface of your vehicle. For more information,
contact your vehicle manufacturer or a professional installer.
6
Fasten the camera clip to the mount base using the two pre-
installed screws .
Appendix
7
Summary of Contents for BC 40
Page 1: ...BC 40WIRELESSBACKUPCAMERA Owner sManual ...
Page 4: ......
Page 13: ......
Page 14: ...support garmin com TA 2018 331 March 2019 190 02365 00_0A ...