8
Adjust the angle of the camera and tighten the hex bolts using the included
hex key.
9
Apply RV sealant around the cable where it enters the vehicle (optional).
Installing the Transmitter
Before you permanently install the transmitter, you must test the installation
location for correct operation (page 2).
1
Secure the transmitter to the installation location using hardware appropriate
for the location, such as screws, bolts, or cable ties.
The fuse holder located near the transmitter is not waterproof. Installing the
fuse holder in a location that is exposed to the elements is not recommended.
2
Connect the camera and transmitter cables.
The connector between the camera and the transmitter is not waterproof. If
you make this connection in a location exposed to the elements, you must
make sure that the connection is waterproof.
3
Connect the power cable
À
from the transmitter to a 12–24 VDC power
source, preferably a reverse lamp
Á
, using a solderless wire-splice
connector (not included).
NOTE: Connecting the transmitter to an always-on 12-24 VDC source (such
as a running lamp) instead of a reverse lamp requires you to manually switch
power to the transmitter. The transmitter may drain your vehicle battery if it is
left on.
4
If you did not use a solderless wire-splice connector, solder and heat-shrink
the electrical connections to protect them from the elements.
Pairing the Camera with a Garmin Navigation Device
You must install AA batteries in the camera before you can pair it to a compatible
Garmin navigation device.
1
Turn on the compatible Garmin navigation device, and bring it within 3 m
(10 ft.) of the camera.
2
Select Apps > Backup Camera, and follow the on-screen instructions.
Multiple Cameras
You can pair up to four wireless cameras with a compatible Garmin device. For
example, you can pair one backup camera installed on the cab and a second
backup camera installed on a trailer. See the BC 35 Owner's Manual for
information about pairing multiple cameras.
Appendix
Getting the Owner's Manual
You can get the most recent owner's manual from the web.
1
Go to garmin.com/manuals/BC35.
2
View or download the full owner's manual in your preferred format.
Specifications
Camera and transmitter input voltage
From 9 to 28 Vdc
Transmitter fuse
500 mA, fast-blow
Camera and transmitter current usage
150 mA at 12 Vdc
4
Confi
denti
al
