Appendix
64
Attaching the Vehicle Adapter to the StreetPilot 2610/2650
Your vehicle adapter is a 12/24 volt DC adapter with an external speaker system. This adapter is your
StreetPilot’s power source when you are in a vehicle (the StreetPilot does not use batteries). Use the AC
adapter (included) when using the StreetPilot indoors.
1. Locate the power connector on the rear of the StreetPilot. The connector is “keyed” with a notch located
towards the bottom of the plug.
2. Mate the power plug on the vehicle adapter to this connector by aligning the notches and sliding the
plug into the connector until fully seated, as shown below.
3. Plug the cigarette lighter portion of the vehicle adapter into an available cigarette lighter receptacle in
your vehicle. Use care when routing the adapter cable to ensure that it does not interfere with vehicle
operation in any way.
Vehicle Installation
The vehicle adapter comes with an external speaker
system that enables you to hear directions from your
StreetPilot.
Periodically, you may need to change the fuse
that’s located at the tip of the vehicle adapter.
Simply unscrew the black, round end piece and
remove/replace the fuse.
A 3AGC/3AG 1 amp
fuse is located at
the tip of the vehicle
adapter
Attach the vehicle adapter to the back of your
StreetPilot as shown above.
Summary of Contents for 2610/2650
Page 94: ......
