4
SPEEDGUARD I POCKET MOUNT
INSTALLATION INSTRUCTIONS
Use the charts and diagrams on pages 3 to guide your installations. Note the location of
each stake pocket holder.
Step 1:
Insert each rail holder into flatbed stake pockets. Refer to page 3 for spacing.
Looking at the truck
’s bed, notice stake pockets are located 2 feet on center from each
other and an additional channel may be on the corner of bed. Use the first side stake
channel as shown.
Continue to Page 6 to continue installation.
Use the first
stake pocket to
start
Do not use
the corner
channel
NOTICE
FALLS FROM TRUCK BED CAN CAUSE SERIOUS INJURY OR DEATH
This fall protection system must be installed by a person standing on the ground or floor.
