Garlando Toorx TRX 8500 EVO, Instructions Manual, Page: 7 / 20

9
running belt by hand, check whether the rotation is flexible, there is no abnormal sound.
2. Connect power, press Start key, the treadmill starts to run in low speed,observe whether
belt and computer are run normally.
3. Press the speed up and down key to observe the rotation and display of the treadmill. If
the belt deviated, stop the treadmill and adjust the running belt according to the requirements
of "maintenance".
4. Press emergency stop key or pull out safety key,the treadmill will stop immediately. Re-
inset the emergency stop key to reset or insert safety key, can restart treadmill. (As below
figure)
5.Press Stop key, the treadmill stop running, then turn off the power when the incline returns
to zero.
Treadmill can be put into use after all the installation adjustment is completed.
1.Two feet stand on two side of belt, put the other side clip from safety key to clip to clothes.
(see the figure)
2.Press Start key, the treadmill will start running at lowest speed. You can step on the belt
and walk slowly.
3.Press speed+ key, the speed of running belt will gradually increase, you can see the speed
value from computer, start to run at low speed for 2-3 minutes, then increase the speed to
your target, you can release the handlebar after
after run is suitable, you can let go handrail to
run after adaptation.
4.When stopping running, you should slow
down gradually and run for 2-3 minutes at a low
speed, so that the heart and breathing slowly
return to normal.
5.After running, you can reduce speed to the
minimum, and then press the start/stop button
to stop the treadmill.
6. If running at high speed, it is too late to slow
down, or even lose balance, you can press the
emergency stop button, and the treadmill can
stop running immediately. The stopping distance depends on the inertial weight.
7. Please fully master the use of emergency stop button and safety key.
8.If the emergency stop button and safety key fail or are damaged, they must be
maintained or replaced by professionals in time. (They are earsily worn parts)
9. Noise under load is higher than that without load.
WARNING: Frequent use of incline operation (more than 5 times in a row) may
render the incline ineffective. It's not a malfunction. It is a kind of automatic