P151 Rev. 1 (03/05)
Page 14
WARNING: Turn off the gas supply to the appliance
at the service cock and the
electrical mains before commencing any servicing
work.
IMPORTANT: Test for gas soundness on completion
of any servicing work.
Gas Taps
1. Pull the knob off of each gas tap and thermostat on
the unit.
2. Remove the screws securing the fascia panel and
remove panel and grease drawer.
3. Remove the appropriate burner (if necessary)
following the procedure given in the section on
Main Burner Cleaning.
4. Disconnect the thermocouple connection at the gas
tap.
5. Disconnect the pilot and main burner tubing
connections at the gas tap.
6. Disconnect the tubing connection at the inlet of
the gas tap and remove the tap.
7. Replace with the new tap.
8. Reassemble in the reverse order.
Door Switch
1. Remove the lower kick panel.
2. Disconnect the wires from the terminals on the
body of the switch.
3. Remove the screws securing the door switch to the
mounting bracket and remove the door switch.
4. Replace the faulty door switch.
5. Make certain that the newly installed door switch
is properly adjusted so as to interrupt the p o w e r
supply to the gas control system and fan motor
when the oven doors are opened.
REPLACEMENT OF PARTS
Control Panel Rocker Switches
1. Remove the fastener securing the control
compartment access panel.
2. Slide out the control drawer to access the switch.
3. Disconnect the wires from the taps on the switch.
Be sure to note which wire connects to which
terminal on the switch.
4. Depress the tabs of the switch body and push the
switch through the opening in the control panel.
5. Replace the switch and reassemble in the reverse
order.
Thermostat
1. Remove the fastener securing the control
compartment access panel.
2. Slide out the control drawer to access the
thermostat.
3. Remove the dial from the thermostat and the screws
securing the thermostat body to the
control
panel.
4. Remove the wires from the thermostat terminals.
Be sure to note which wire connects to which
terminal on the thermostat.
5. Remove the thermostat sense bulb.
6. Replace the faulty thermostat and reassemble in the
reverse order.
Heat-On Lamp
1. Remove the fastener securing the control
compartment access panel.
2. Slide out the control drawer to access the lamp.
3. Disconnect the supply wires to the lamp body and
remove the faulty lamp.
4. Reassemble in the reverse order.
Summary of Contents for STARFIRE SENTRY STW286
Page 16: ...P151 Rev 1 03 05 Page 16 WIRING DIAGRAMS ...
Page 18: ...P151 Rev 1 03 05 Page 18 NOTES ...
Page 19: ...P151 Rev 1 03 05 Page 19 NOTES ...
Page 20: ......
