4517957 Rev. 2 (06/05)
Page 19
4. Break the pipe union connection at the inlet of the
gas control and the 7/16” union connection located
at the outlet of the control.
5. Remove the wires from the connections to the gas
valve. Be sure to note which wires connect to which
terminal before doing so.
7. Replace the control and reassemble in the reverse
order.
Front Cooling Fan
1. Remove fastener securing the control compartment
access panel.
2. Slide out the control drawer.
3. Disconnect the fan supply harness form the unit
wiring harness.
4. Remove fasteners retaining the fan and set aside.
5. Replace the faulty motor.
6. Reassemble in the reverse order.
Motor
1. Open the oven doors.
2. Remove the oven racks and guides.
3. Remove the two (2) wing screws securing the fan
guard and remove the guard.
4. Using an allen head wrench loosen the screw
securing the blower wheel to the motor shaft and
remove the wheel.
5. Remove the four (4) screws securing the motor
mount plate to the oven casing back and pull the
plate forward into the oven compartment.
6. Disconnect the motor wire connections (note which
wire connects to which) and replace faulty motor.
8. Reassemble in the reverse order.
REPLACEMENT OF PARTS continued
Ignition Control
1. Remove the fastener securing the control
compartment access panel.
2. Slide out the control drawer to access the lamp.
3. Disconnect the supply wires to faulty ignition
control (noting the wire connections)
4. Replace the faulty control.
6. Reassemble in the reverse order.
Hot Top Ignition Momentary Switch
1. Remove the griddle grease drawer.
2. Remove the fasteners securing the front panel.
3. Remove the nuts securing the switch box to the
front panel.
4. Disconnect the 2 wires to the switch.
5. Unscrew the switch from the front panel.
6. Replace the switch and reassemble in reverse order.
Hot Top Spark Generator
1. Remove the fastener securing the control
compartment access panel.
2. Slide out the control drawer to access the generator
module.
3. Disconnect the wires to the generator.
4. Remove fastener retaining the generator.
5. Replace the faulty module and reassemble in reverse
order.
Summary of Contents for SRW286A
Page 2: ...4517957 Rev 2 06 05 Page...
Page 32: ......
