Part # 4517127 (06/23/08)
Page 12
Holding the bottom of the release material sheet in place,
gently pull the sheet toward the front of the platen.
Thread the front edge of the release material sheet behind
the release material bar on the front of the platen, then
around the top and down over the front of the bar as shown.
Place locking clips over release material sheet and press into
place over release material bar.
RELEASE
MATERIAL
LOCKING
CLIP (1)
RELEASE
MATERIAL
BAR
RELEASE
MATERIAL
UPPER PLATEN (side view)
FRONT OF GRILL
Check alignment and tightness of release material against
upper platen.
NOTE: Make sure release material fits smoothly over upper
platen. Installing release material sheets too tight may cause
premature failure of the sheet.
Release sheets are reversible and should be flipped over
and reattached on a daily basis. For instructions on cleaning
release sheets, see Step 17., in daily cleaning, under
CLEANING AND MAINTENANCE section.
A release material sheet must be replaced when:
• Product sticks to release material.
• Carbon build-up causes problems in taste or appearance.
• Tearing occurs in the sheet’s cooking area.
• Release material coating is worn off sheet.
Lighting Instructions:
1. Ensure that the flexible gas hose is connected to the grill
and the power cords are plugged into the receptacles.
2. Turn the main power switch ON and allow the controls
to go through the power-up self-check. Once the control
panel displays the word “OFF” the unit is ready to begin
the heating process.
3. Press . The control will automatically initiate the
heating cycle. The burner will ignite and heat until the
temperature specified by the menu item has been
obtained.
If ignition of the burner does not occur on the first trial, the
bottom indicator light will flash amber. If the burner(s) do not
light within four trials for ignition, the control will display a
flashing warning, “IGNITION ERROR.” The flashing amber light
will turn to solid red and an audible alarm will sound. If this
occurs, turn the main power switch off, wait 5 minutes, and
then repeat steps 2 and 3.
To Cook in Two-Sided Mode:
1. Select a menu item by pressing or until the desired
menu item is displayed. Press the Gap Setting Number
desired for the selected item, (Gap Buttons 1-5, or hold
for 6-10). The display may read either “TOO COOL” or “TOO
HOT,” (alternating with the ‘MENU ITEM’), until the grill
attains the set temperature range for that menu item,
then the “MENU ITEM,” and the gap setting alternating
with the Gap Button number will be displayed.
NOTE: If the display reads either “TOO COOL” or “TOO
HOT” the upper platen will not lower and initiate a
cooking sequence.
2. After loading the grill with product, press the GREEN,
(‘CANCEL/RAISE’), and the BLACK buttons at the same
time. An audible alert will sound and the platen will lower
to the preset gap and the timing will automatically start.
3. When the cook timer reaches one, (1), second remaining,
a pre-time-out alarm will sound to alert the grill operator.
4. When the cooking time has been completed, “PRODUCT
NAME” and “REMOVE” will be displayed with an audible
alert. Cooking is complete. Remove product.
5. To cancel a cooking cycle, press and hold the GREEN
(‘CANCEL/RAISE’) button. The upper platen will rise. The
display will flash “CANCEL” with an audible alert.
OPERATION continued
Summary of Contents for MASTER SERIES XG24CE GB/IE
Page 31: ...Part 4517127 06 23 08 Page 31 ...
Page 32: ......
