Quick Start Guide for Magnum 6K and 10K series switches - 5
Modem Cable to the following parameters
Bits per second: 38400
Data bits: 8
Parity: None
Stop bits: 1
Flow Control: None
This will provide access to the switch console access. Once you have access to the switch
Command Line Access (CLI)
Power Cycle the switch by turning Power off and then turn on, boot up process will appear on
the console screen
On the console screen, you will see following message Bootloader version, and the Application
version, and then it will start uncompressing the application file, once you see the uncompressing
...done, instantly press Ctrl and X key simultaneously couple of times in succession. This will set
the switch to factory default
Note:
I would highly recommend to have your finger on Ctrl and X key as soon as you see the
Uncompressing word on the screen, and press Ctrl and X key as soon as you see
Uncompressing ...Done. If you delay in pressing the keys, it will start loading the old configuration.
If you miss it, power cycle the switch again, and follow the process again. If you see the message
on the next screen, it means the switch has reset to factory default, and then you will be able to
login factory default login: manager and Password: manager