INSTRUCTIONS FOR 75405/75375 DECK MOUNT
Hardware Required
(8)
#14 stainless steel wood screws of suitable length
Refer to Fig. 2:
1. Determine desired location of table. Using the
square/round mount socket base as a template, mark eight
mounting hole locations. Find the center point of location
by scribing two lines diagonally between corner mounting
holes. The center point is where these two lines cross.
Scribe a 3-3/4" diameter circle around this center point.
NOTE: Make certain that the area under the floor directly
below the marked hole locations is free from
obstacles such as fuel tanks, hoses, electrical
wires, etc.
2. Use a 3-1/4" hole saw or a keyhole saw to cut out a
3-1/4" circle.
3. Drill eight 1/16" diameter pilot holes.
4. Secure socket base in place with selected fasteners.
5. Insert tapered end of table leg into socket base. Slide table
onto horizontal portion of table leg, level and secure with
locking knob (B).
REMOVAL AND STOWAGE OF PORTABLE COCKPIT TABLE
Refer to Fig. 3
1. To rotate table top, loosen locking knob (A) until bracket
rotates freely, secure top by rotating to desired position
(horizontal or side).
2. To remove top, loosen locking knob until bracket rotates
freely, then slide top off for stowage.
3. To rotate table post:
• Model 75045 – To loosen table post, rotate while pulling
upward to either rotate or remove from the deck mount
socket base.
• Model 75400 – Loosen locking knob on wall coaming
bracket (B) until table post rotates freely. Slide table post
out for stowage, or rotate and reposition height before
tightening locking knob.
FIG. 2
FIG. 3
Installation Instructions –
Models 75400, 75401, 75405, 75375 Portable Cockpit Tables
Form 12.476
