14
1.
Check oil level when engine is stopped.
2.
Remove the oil filler cap/ dipstick and wipe it clean.
3.
Insert the oil filler cap/ dipstick into the oil filler neck
without screwing it in; remove it to check the oil level.
4.
If the oil level is near or below the lower limit mark on the
dipstick, refill with the recommended oil to the upper limit
mark (bottom edge of the oil fill hole). Do not overfill.
5.
Reinstall the oil filler cap/ dipstick.
7.1.3 Adding
fuel
DANGER!
Petrol is highly flammable.
Use unleaded gasoline with a pump octane rating of 86 or higher. This engine is certified to operate on unleaded
gasoline. Unleaded gasoline produces fewer engine and spark plug deposits and extends exhaust system life.
Never use an oil/ gasoline mixture.
●
Stop engine and keep heat, sparks, and open fire away.
●
Refuel only outdoors.
●
Wipe up spills immediately.
Fuel can damage paint and some types of plastic. Be careful not to spill fuel when filling your fuel tank. Damage
caused by spilled fuel is not covered under warranty. Never use stale or contaminated gasoline. Avoid getting
dirt or water in the fuel tank.
1.
Remove the fuel cap.
2.
Add fuel to the bottom of the fuel level limit in the neck of the fuel tank.
3.
Do not overfill. Wipe up spilled fuel before starting the engine.
4.
Install and tighten the fuel cap.
5.
Fuel tank capacity:
1.8 l
7.2 START ENGINE AND ENGAGE BLADE
7.2.1 for GBD-46R (DYM1676CE-3) & GBD-51R (DYM162601)
1. The unit is equipped with a rubber tip #10 on the spark plug, make sure it is fastened securely.
2. Open the fuel valve (fig. 31). Set it to the “
“ position.
3. For a cold start, turn the choke lever #13 to “
” position. Immediately after the engine starts
turning, turn the choke lever to the “
” position (fig. 32/ 33).
4. Standing behind the unit, push & hold the brake control handle against the upper handle (fig. 34).
5. Pull out the starter handle slowly until you feel a resistance in the rope. Then completely pull the rope out
with one fast movement. Once the engine starts, return it slowly to the rope guide bolt (fig. 35).
Release the brake control handle to stop engine and blade.
6. After having finsihed to mow, please turn the fuel lock to the ”
”.position (fig. 36).
