Operation
Operation manual VCpro 600
39
Pos.
Element
Function
1
<OK>
Sets current pressure as setpoint, only possible with active
operating mode
<Down>
Decrease setpoint with active operating mode
by 1 mbar when pressed once
continuously when pressed and held
<Up>
Increases temporary setpoint for active operating mode
by 1 mbar when pressed once
continuously when pressed and held
2
<Pmin>
Starts maximum pressure reduction
<Air>
Opens the ventilation valve when pressed or
closes it when released
3
<Start Mode>
Selection of the operating mode that should be started
<Start / Stop>
Starts or stops the active operating mode
6.4.4
File
File
Save settings
Save settings of the Settings dialog in a file
Load settings
Load settings of the Settings dialog from a file
Save memory
Save the pressure data in a file
Load memory
Load the pressure data from a file
Print curve
Print the current pressure curve on the default printer
Password
The password protects the factory settings of the vacuum controller.
WELCH service can use the password to change
the vacuum controller's factory settings.
Info
Information about the software version
Firmware update
Install the selected firmware file on the end device
Exit <ESC>
Exit PC software
