![background image](http://html1.mh-extra.com/html/gardner-denver/welch-lvs-105-t-10-ef/welch-lvs-105-t-10-ef_operation-manual_3569511045.webp)
Operation
Operation Manual LVS 105 T
– 10 ef
+
45
Pos.
Element
Function
1
<OK>
Sets the current pressure as the setpoint, only possible with
active
operating mode
<Down>
Decrease setpoint with active operating mode
by 1 mbar when pressed once
continuously when pressed and held
<Up>
Increases the temporary setpoint when the operating mode
is active
by 1 mbar when pressed once
continuously in 1 mbar steps when pressed and held
2
<Pmin>
Starts maximum pressure reduction
<Air>
Opens the ventilation valve when pressed and closes it
when released
3
<Start Mode>
Selection of the operating mode that should be started
<Start / Stop>
Starts or stops the active operating mode
6.4.4
File
File
Save settings
Save settings of the Settings dialog in a file
Load settings
Load settings of the Settings dialog from a file
Save memory
Save the pressure data in a file
Load memory
Load the pressure data from a file
Print curve
Print the current pressure curve on the default printer
Password
The password protects the factory settings of the vacuum controller.
WELCH service can use the password to change the controller's fac-
tory settings.
Info
Information about the software version
Firmware update
Install the selected firmware file on the end device
Exit <ESC>
Exit PC software