COMMISSIONING OR RECOMMISSIONING
PAGE 32
7.2 START-UP PROCEDURE
Check radiator is topped up on radiator sets or water is flowing in correct volume in mains water
installations.
Operate starter.
Check immediately that the direction of rotation is counter-clockwise looking on driving end.
Check that oil pressure is above 2 bar.
W A R N I N G:-
THE COMPRESSOR SHOULD NOT BE RUN FOR LONGER THAN 30 SECONDS WITH NO OIL
PRESSURE.
Check there are no uncharacteristic noises.
Run for 30 minutes unloaded.
Stop and isolate the compressor and release all pressures. Check that outer surface of machine is cool
Remove crankcase doors and check that bearings and running gear are not over-heating.
Replace doors, ensuring joints are correctly seated.
Close drain valves and/or replace plugs.
Restart the compressor and bring slowly onto load. Build up to full pressure within 1 hour.
If appropriate, set the compressor for automatic operation.
Check and adjust the control equipment settings, if applicable (for example, pressure switch and time
delays in starter).
Continue to check that machine is functioning correctly and not over-heating.
Observe stage pressures and temperatures are normal.
Check for air, water or oil leaks.
WARNING:-
Do not try to correct leaks when items are pressurized.
Ensure the automatic controls (if applicable) are operating correctly.
If machine is manually controlled, open all condensate drains at 30 minute intervals.
Adjust cooling water flow to give 11°C rise across machine.
Run at full load for one and a half hours and record compressor rpm, oil pressure and stage pressures at
30 minute intervals.
Summary of Contents for Reavell H5000 Series
