Page 16
13-17-625 v00
3.3 Operating Mode Setting
Next, the operating mode for machine control needs to be configured. Navigate to the control
settings menu following Figure 11
by selecting Menu, Settings, and then Control. Change the
operating mode to
Sequencing
, shown in Figure 12.
Figure 11: Menu Navigation to Control Settings
Figure 12: Operating Mode Setting in Control Settings Menu
3.4 Sequencing Settings
Next, navigate to the sequencing settings menu as shown in Figure 13. Figure 14 shows the
sequencing settings screen and all of the different settings that can be configured. Table 2
at the
end of this section outlines the settings associated with the AirSmart sequencing protocol in more
detail and shows the default parameters that are set in the controller. The parameter settings are
different depending on the sequence mode selected while configuring the RS485 communication
settings. The Capacity settings will vary depending on the machine size, while other default values
Summary of Contents for Governor
Page 42: ...Page 42 13 17 625 v00 NOTES...
Page 43: ...Page 43 13 17 625 v00 NOTES...
