13-17-621 Page 187
TV Full open
When active, turn valve is forced to a fully open position
TV Full close
When active, turn valve is forced to a fully closed position operating at
full flow.
Remote Speed Control
An analog input that will control the percent load of a machine when the
speed control source is set to remote.
For each parameter there are two statuses.
I/O Status
and
Communication Status
.
I/O Status:
The
I/O
Status
is shown as
ON
or
OFF
for each of the parameters. If toggled
ON
it means the digital input
assigned to this function is
active
. Note that this could mean that the physical input is high or low depending
on configuration of the input.
Communication Status:
The
Communication Status
is shown with either
ON
or
OFF
. If toggled
ON
it indicates that the bit
representing this function in the communication interface is
active
.
Figure 216 below shows an example of the
Remote Control
page.
Figure 216: Remote Control
6.8 VFD Diagnostics
The
VFD Diagnostics
page lists information specific to the variable frequency drive connected to the
machine. There is also important motor data listed here, as shown in Figure 217 below.
