13-17-621 Page 77
Figure 104: Timer Control
Time
can also be set from the
Settings > Configuration > Locale
menu. Refer to Section 4.3.2 for more
details, the same logic to change these settings applies.
4.5.1 Timer Start Stop:
Hit the
Timer Start Stop
button and it will bring the user to the
Timer Config
settings. As you can see in
Figure 105 below, all the channels are set to
off
. We can set up to 8 different sets of time and days labeled
as channels. Each timer control channel controls a compressor switch-on time and a compressor switch-
off time that can be set for one or more days of the week.
Figure 105: Timer Start Stop
To configure one of the channels, hit the button labeled
Off
next to the channel you want to set. If the
channel has already been configured the button will be labeled
On
. This will navigate you to the
Channel
Setting Screen
as shown in Figure 106 below.
