![background image](http://html1.mh-extra.com/html/gardner-denver/edf-kb/edf-kb_operating-and-service-manual_3676904056.webp)
13–8–606 Page 48
SYMPTOM
POSSIBLE CAUSE
REMEDY
Erroneous Pressure Readings
1.
Electrical noise creating
1.
Make sure transducer wires
[135 – 150 psig constantly].
false readings.
are kept to a minimum length
(9.3 – 10.3 Bars)
and are twisted.
2.
Loose connector.
2.
Measure the DC voltage
between the green and black
wires of the corresponding
transducer at the control
board with zero pressure on
the transducer. If .460 to
.540 volts, replace the plug–
gable connector that connects
transducers to the board.
3.
Bad transducer.
3.
Measure the DC voltage
between the white and black
wires of the corresponding
transducer at the control
board with zero pressure on
the transducer. If 3.10 to
3.60 volts, replace the
transducer.
Oil leak at the bottom of
1.
Gasket leaking.
1.
Replace the gasket.
the seal housing.
2.
Plug leak.
2.
Repair.
3.
Capscrew leaking.
3.
Repair.
4.
Shaft seal leaking.
4.
Change the seal.
Fuse on board blows.
1.
Bad board.
1.
Remove all power from the
unit by opening the main
disconnect, replace fuse,
energize main power. If fuse
blows – replace board.
Fuse on transformer blows.
1.
Shorted coils on hour
1.
If fuse does not blow, check
meter, starter coil,
for shorted coils.
or blowdown valve.
Gardner Denver factory remanufactured replacement compressor air end units
are available from your authorized distributor, on an exchange basis, for all rotary
screw compressor units.
Summary of Contents for EDF-KB
