1
502-2 & 503-2 instructions
instruction manual
Slug Out™ Knockout Driver
KOMD1 / KOM540A / KOM520A
gardnerbender.com
IMPORTANT: SHIPPING DAMAGE
Visually inspect all components for shipping damage.
If any shipping damage is found, notify carrier at once.
Shipping damage is NOT covered by warranty. The carrier
is responsible for all repair or replacement costs resulting
from damage in shipment.
CAUTION
Read and understand instruction sheet. FAILURE TO DO
SO MAY RESULT IN SEVERE INJURY.
DESCRIPTION OF OPERATION
The Mechanical Driver is a torque multiplying device
powered by an electrical driver drill. It is intended to be
used with the Slug Out™ punches, dies, and draw studs
to punch holes in electrical panels. Round punches are
available from 1/2" to 4" (12.7mm to 101.4mm).
IDENTIFICATION
1. Handle
2. 3/4" draw stud receiver
3. 3/8" draw stud receiver
4. Square drive bit receiver
5. Punches
6. Dies
7. 3/4" draw stud
8. 3/8" draw stud
9. Square drive bit
10. Step drill bit
1.
2.
5.
6.
3.
10.
9.
8.
7.
4.
