2
800.624.4320 • Milwaukee, WI 53151 • gardnerbender.com
GAR_TL_081_0819_GWL-40
One Year Warranty limited solely to repair or replacement; no warranty of merchantability or fitness for a particular purpose. Product is warrantied
to be free of defects in materials and workmanship for the normal life of the product. In no event shall Gardner Bender be liable for
incidental or consequential damage.
CLEANING
Before cleaning, please remove the plug from the power socket. For reasons regarding electrical safety, please clean this product with a damp cloth.
Do not use any harsh cleaning agents or chemicals.
WARRANTY INFORMATION
The guarantee is not applicable for not following the instructions and improper handing of the lamp or lamps of individual part. Forcibly opening the
lamp will void the warranty! For Operating and connection errors beyond our control and resulting damages, we assume no liability.
NOTE: The external flexible cable or cord of this luminaire cannot be replaced; if the cord is damaged, the luminaire shall be destroyed.
The light source of this luminaire is not replaceable; when the light source reaches its end of life the whole luminaire shall be replaced.
Repairs may only be carried out by an authorized service centre. Original bill of purchase must be submitted.
The warranty will not apply in cases of: normal wear and tear, changes, modifications, damage caused by careless, external influences, any application
this product is not meant for or partially or completely dismantled appliances.
Surface Mounted
Luminaires not suitable for direct mounting on
normally flammable surfaces (suitable only for
mounting on non-combustible surfaces).
FCC WARNING STATEMENTS:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
CLASS B DEVICE:
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet an a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
OPERATING INSTRUCTIONS
1. Powering the Light ON/OFF
Unwrap power cord plug, Figure 3 (E) to desired length and plug into a functioning electrical outlet. Press the On/Off Switch (A), Figure 1.
For Safety purposes, when done using the light always wrap the power cord and extension in the Easy Cable Storage (D), Figure 3.
2. Adjusting Stand & Lighting Angle
The tilting angle of the light can be adjusted as necessary by pulling the stand (B), Figure 1 and locking in place.
The lighting angle can be adjusted by lightly pulling down on the swivel LED body (C), Figure 2.
3. Mounting the Light with Magnets
The 4 heavy duty magnets on the back of the light can be used to mount the light to any metal device that is large enough and safely secured
to support the weight of the light. After the light is mounted by the magnets, be sure to double-check it securely mounted to avoid it falling
and potentially causing injury and/or damage.
4. Using Extension Cord
Unwrap extension cord connector, Figure 3 (D) to desired length and plug in secondary desired powered device (125V ~ Max.1500W).
To avoid injury or harm, be sure the secondary device is turned off or that the light On/Off switch (A) is in the OFF position so
the secondary item does not immediately power on.
