9
△
△
△
△
,!
DANGER ZONE
NO PERSON EXCEPT OPERATOR ALLOWED 15 METERS RADIUS DANGER ZONE. EYE,
EAR, FACE, FOOT, LEG AND BODY PROTECTION MUST BE WORN BY OPERATOR.
PERSONS IN ZONE OR RISK BEYOND DANGER ZONE SHOULD WEAR EYE
PROTECTION AGAINST THROWN OBJECTS. RISK DIMINISHES WITH DISTANCE FROM
DANGER ZONE.
CUTTING WITH A NYLON HEAD
For nearly all cutting, it is good to tilt the line head
so that contact is made on the part of the line circle
where the line is moving AWAY from you and the
debris shield. (See appropriate) This results in the
debris being thrown AWAY from you.
TRIMMING:
This is feeding the trimmer carefully into the
material you wish to cut. Tilt the head slowly to
direct debris away from you. If cutting up to a
barrier such as fence, wall or tree, approach from
an angle where any debris ricocheting off the
barrier will fly away from you, Move the line head
slowly until the grass is cut right up the barrier, but
do not jam (overfeed) the line into the barrier. If
trimming up to a wire mesh or chain linked fence be
WARNIN
△
△
△
△
,!
DANCER
The proper debris shield must be in place on
the unit when nylon cutting line is used, The
cutting line can flap around if too much line is
exposed. Always use the plastic debris shield
with cut-off knife when using nylon cutting
heads.
WARNING
△
△
△
△
,!
DANGER
Tilting the head to the wrong side will shoot the
debris TOWARDS you. If the line head is held
flat to the ground so that cutting occurs on the
whole line circle, debris will be THROWN at you,
drag will slow the engine down, and you will use
up a lot of line.
WARNING
△
△
△
△
,!
DANGER
Use only quality nylon monofilament line of the
diameter
2.5mm,
Never
use
wire
or
wire-reinforced line in place of nylon trimmer line.
Load your nylon line cutting head only with nylon
trimmer line of the proper diameter.
WARNING
△
△
△
△
,!
DANGER
Use extreme caution when operating over bare
spots and gravel, because the line can throw
small rock particles at high speeds. Debris
shields on the unit cannot stop objects which
bounce or ricochet off hard surfaces.
Summary of Contents for GPDCBT43
