49
WARNING
Improper maintenance and storage of the log splitter may void your warranty.
MAINTENANCE
•
Before performing maintenance, the log splitter must be placed in maintenance mode.
Turn off the engine and move the control lever forward and backwards to relieve the
hydraulic pressure.
•
After performing any maintenance, make sure all guards, shields and safety features are
put back in place before operating the log splitter.
•
Before operating make sure the tires have the RECOMMENDED TIRE PRESSURE.
•
Regularly grease axle and wheel bearing area or when needed.
•
After the wheel bearings have been greased make sure the axle nuts and pins are in place
and secure.
•
Periodically check all fasteners and hoses for tightness and leaks.
•
Annually clean and lightly lubricate all moving parts o
r when needed.
•
Use a glossy enamel spray paint to touch up scratched or worn painted metal surfaces.
•
Never exceed load capacity rating of 12 tons it will damage the log splitter.
What
When
How
Hoses
Each Use
Inspect hoses for exposed wire mesh and leaks.
Replace all worn or damaged hoses before
starting the engine.
Hydraulic Fittings Each Use
Inspect fittings for cracks and leaks. Replace all
damaged fittings before starting the engine.
Nuts and Bolts
Each Use
Check for loose bolts, tighten before operating.
Beam
Each Use
Apply grease to beam surface.
Maintenance and Storage
While towing, connect the hitch tongue to your vehicle and raise the front support
leg. Note, the Lock Pin should be in the upper hole.
When operating, please connect the Front Support Leg to the lower hole with
LOCK PIN and make sure the leg support the floor while operating.
