On First Use
The built-in back-up lithium battery in this product will have been 70-80%
charged upon manufacture. However, on the date of purchase, the battery
will lose its charge during shipping and storage. For best results, allow the
solar panel to charge the battery for a full day in direct sunlight before
using the pump.
Direction for Use
This water feature is designed to run during the day in direct sunlight. Any
excess power produced via the solar panel will be used to charge the back-up
battery. This will allow for running of the pump and LED light in the evening.
Please note, the evening runtime will vary depending on charge level of battery
and weather conditions.
The LED light automatically illuminates in the evening, if there is sufficient
charge in the battery.
How to Turn On The Unit
To turn on the unit to start running the pump and
the LED light, turn the switch to the “I” position for
it to turn on. The switch is located at the top of the
solar/sprinkler unit (see figure 3).
How to Charge The Lithium Battery
To switch off the pump, turn the switch to the “O” position. When the pump is
switched off, all of the charge generated by the solar panel will be stored in the
back-up battery.
Please note, this may have to be done periodically during inclement weather.
Cleaning and Maintenance
Pump
If the pump stops working or is running slow, you will need to disassemble
and clean the pump to remove any debris/limescale from the filter and motor
chamber, as shown in Figure 4.
Figure 3
