GARDENTEC GTT4002, User Manual, Page: 15 / 27

15
- Fit the steering connector(18), as shown, to the motor hoe.
- Use hexagonal screws, spring washers and washers to mount on both sides.
Mounting the steering
▶
P.4, item 7
- Hold the left steering bar(19) up against the side of the unit and secure with
hexagonal screw and washers.
- Do the same for the steering bar on the right (20).
▶
P.4, item 8
- Fit the steering cover (21) and screw into place from behind using 4 screws.
Mounting the chopping spur
▶
P.5, item 9
- Fit the chopping spur(5).
- Put the bolts (22) through holder and spur at the required height.
- Use a pin(23) to fix the bolt into place.
___________________________________
Initial start up
Unit and operating elements
Steering
Set the steering height:
▶
P.5, item 12
- Loosen the screws.
- Set the required steering height.
- Tighten the screws.
Gas handle

Gas handle at position[ STOP ] = Motor off;

Gas handle at position[ ] =Minimum motor revolution;

Gas handle at position[ ] =Maximum motor revolutions;
Coupling handle