*
Butane Gas Torch and solder available from Gardens at Night.
3
5
6
7
8
To re-mount light fitting to bracket:
Assemble fitting body into mounting
bracket & align holes in bracket sides
with mount points in fitting body (A).
Re-attach fitting to bracket with
supplied bolts and washers (B).
Rotate and position light fitting to light
desired area and tighten bolts evenly.
Cut and remove two solid tinned ends
from fitting cable.
Strip PVC insulation from fitting cable
to expose strands (A).
Cut incoming feed cable from power
supply (B).
Strip PVC insulation to expose copper
strands from incoming feed cable (B)
and exiting cable (C).
Fan out all exposed copper
strands (A).
Tightly twist positive fitting, feed and
exiting cable (B), ensuring shoulders of
PVC insulation remain aligned.
Repeat for negative cables.
Heat twisted copper with Butane Gas
Torch* and apply solder (A).
Solder should fully penetrate all
strands (B).
Trim solder with side cutters and
carefully remove any sharp edges (C).
Repeat for other cable join.
Fitting cable
Feed cable
Solder
