17
17
AFTER SALES SUPPORT
e-mail: [email protected]
1300 889 028 (toll free)
MODEL No.: HYSB-125PP
62809 01/2019
You must connect the DC power supply via the correct polarities;
incorrect connection may damage the pump.(Never modify the battery
stand)
Make sure the lithium-ion battery is connected correctly.
Install the outlet pipe accordingly.
Make sure the pump is more than 30cm above the earth, to avoid
suction of any solid impurities.
4.1 Priming the pump
When placing the pump in the water to be pumped, bubbles should be
seen coming from the breather hole (14) on the side of the pump.
This is to ensure the pump is fully primed.
In the case where water is added after the pump is installed, the priming
operation will occur automatically through the breather hole (14).
IMPORTANT:
It is important the outlet of the pump is NOT
immersed
in a pond or tank etc, if it is higher than the pump. Otherwise, when
the pump stops, the above water reserve will siphon back through the
pump. Always leave an air break on the drainage pipe into the drain
area.
NOTE:
Never pump high viscosity liquids, such as mud, sludge, or oily
water. It is recommended to install the battery stand (1) in a dry and
weather protected area.
4.2 Switching on and off
1. To switch on, depress the on/off switch (5) to “I” .(See Fig E1)
2. To switch off, depress the on/off switch (5) to “O”.(See Fig E2)
WARNING: The battery stand is not waterproof, it cannot be
put into the water.It is recommended to install the battery
E2
E1
