AFTER SALES SUPPORT
AFTER SALES SUPPORT
+44 (0)1904 727501
+44 (0)1904 727501
+353 (0)1 902 2605
+353 (0)1 902 2605
www.coreservice.co.uk
www.coreservice.co.uk
17
18
38CM Push Mower
38CM Push Mower
GB
GB
IRE
IRE
GB
IRE
GB
IRE
Maintenance Tips:
− Push mowers are relatively low maintenance. For consistent
cutting follow the below instructions.
− Always keep the cutting bar properly adjusted. Refer to the
instruction manual for further directions.
− Regularly clean and lubricate the cutting edges with light
spray oil.
IMPORTANT:
Push mowers have difficulty cutting tall weeds such as
dandelions which may cause the weeds to bend
WARNING!
Only perform the steps described within these
instructions! All further inspection, maintenance and
repair work must be performed by an authorised service
centre or a similarly qualified specialist if you cannot
solve the problem yourself!
Maintenance Tips
Cleaning
Cleaning
WARNING!
Mower blades are sharp. Wear gloves and use extra
caution when servicing them. Any wheel rotation can
cause the blade to rotate.
Do not over-tighten adjustment screws as this could
damage the cutting bar. Screws must be tight on final
adjustment.
The blade is adjusted for proper clearance from the cutting bar
at the factory. However, after extended periods of mowing or as
part of annual maintenance, it is recommended that the blade
clearance be readjusted .
− If blade clearance is too wide the cutting pattern will be rough
and uneven.
− If blade clearance is too narrow, the machine will be noisy and
difficult to push while operating.
