AFTER SALES SUPPORT
AFTER SALES SUPPORT
+44 (0)1904 727501
+44 (0)1904 727501
+353 (0)1 902 2605
+353 (0)1 902 2605
www.coreservice.co.uk
www.coreservice.co.uk
11
12
43cm Electric Lawnmower
43cm Electric Lawnmower
GB
GB
IRE
IRE
GB
IRE
GB
IRE
Safety
Safety
− This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
− Don’t use the appliance without reading the instruction
sheet.
− Children should be supervised to ensure that they do not
play with the appliance.
Work area safety
− Keep the work area clean and well lit. Cluttered or dark areas
invite accidents.
− Do not operate power tools in explosive atmospheres, such
as in the presence of flammable liquids, gases or dust. Power
tools create sparks which may ignite the dust or fumes.
− Keep children and bystanders away while operating a power
tool. Distractions can cause you to lose control.
Electrical safety
− Power tool plugs must match the outlet. Never modify the
plug in any way. Do not use any adapter plugs with earthed
(grounded) power tools. Unmodified plugs and matching
outlets will reduce the risk of electric shock.
− Avoid body contact with earthed or grounded surfaces,
such as pipes, radiators, ranges and refrigerators. There is
an increased risk of electric shock if your body is earthed or
grounded.
− Do not expose power tools to rain or wet conditions. Water
entering a power tool will increase the risk of electric shock.
− Do not abuse the cord. Never use the cord for carrying,
pulling or unplugging the power tool. Keep the cord away
from heat, oil, sharp edges or moving parts. Damaged or
entangled cords increase the risk of electric shock.
− When operating a power tool outdoors, use an extension cord
suitable for outdoor use. Use of a cord suitable for outdoor
use reduces the risk of electric shock.
− If operating a power tool in a damp location is unavoidable,
use a residual current device (RCD) protected supply. Use
of an RCD reduces the risk of electric shock. The maximum
operating current of the RCD must be less than 30mA.
− The voltage indicated on the rating plate must correspond to
the voltage of the power source.
− Only use or replace power supply cables for this unit which
correspond to the types indicated by the manufacturer. See
the operating instructions for the order no. and types.
− Never touch the mains plug with wet hands.
− Do not run over, crush or pull the power s upply cable or
extension lead, otherwise it may be dam aged. Protect the
cable from heat, oil and sharp edges.
− The extension lead must have a cross section in accordance
with the operating instructions and be protected against
splashed water. The connection must not be in water.
Power tool use and care
− Do not force the power tool. Use the correct power tool for
your application. The correct power tool will do the job better
and more safely when operated at the rate for which it was
designed.
− Do not use the power tool if the switch does not turn it on and
off. Any power tool that cannot be controlled with the switch
is dangerous and must be repaired.
− Disconnect the plug from the power source and/or the