CORDLESS LAWN MOWER
CORDLESS LAWN MOWER
GB
IRE
GB
IRE
After Use
1. Switch the product off, disconnect the safety key from the tool and remove the
battery pack and let it cool down.
2. Check, clean and store the product as described below.
Care and maintenance
WARNING!
Always switch the product off, disconnect the battery pack from the
tool and let the product cool down before inspection, maintenance and
cleaning work!
1. Keep the product clean. Remove debris from it after each use and before storage.
2. Regular and proper cleaning will help ensure safe use and prolong the life of the
product.
3. Inspect the product before each use for worn and damaged parts. Do not operate it
if you find broken and worn parts.
WARNING!
Only perform repairs and maintenance work according to these
instructions. All further works must be performed by a qualified
specialist.
General cleaning
1. Clean the product with a dry cloth. Use a brush for areas that are hard to reach.
2. In particular clean the air vents after every use with a cloth and brush.
3. Remove stubborn dust with high pressure air (max. 3 bar).
Note:
Do not use chemical, alkaline, abrasive or other aggressive detergents or
disinfectants to clean this product as they might be harmful to its surfaces.
4. Check for any damage and wear. Repair damages in accordance with this instruction
manual or take it to an authorised service centre before using the product again.
Spare parts/Replacement parts
The following parts of this product may be replaced by the consumer. Spare parts are
available at an authorised dealer or through our customer service.
Description Model no. or Specification
Battery pack B0P136AA (10INR19/65)
Battery charger B0Q136-AB
Grass catcher SLM40K.0.2A
Cutting device (blade) 856203
Underbody and cutting device
WARNING!
Wear safety gloves when working on or near the cutting device.
Use proper tools to remove debris, such as a stick. Never use bare hands.
Always use original spare parts for replacement. Replace the cutting
device only with an identical component carrying the part number
856203. Do not attach any other type of cutting device.
The replacement of the cutting device should be done by an
experienced user.
Rework or sharpening blades is not recommended unless it is done by a
repair service or a similarly qualified specialist.
1. Keep the underbody and cutting device clean and free of debris. Remove clippings
from the discharge chute
2. Check all nuts and bolts periodically for tightness before operation. After prolonged
use, especially in sandy soil conditions, the cutting device will become worn and
lose some of the original shape. The cutting efficiency will be reduced and the
cutting device should be replaced.
3. Keep the cutting device sharp to ensure good cutting performance. Replace a worn
or damaged cutting device with a new one of the same type or have it sharpened
by a qualified specialist.
4. Loosen the bolt (18) anticlockwise using a suitable wrench and remove it together
with cutting device (19) (Fig. 19).
5. Replace the cutting device with a new one of the same type.
Operation/Maintenance/Cleaning
Cleaning
AFTER SALES SUPPORT
+44 (0)1904 727506
+353
(0)124 751 50
www.coreservice.co.uk
GB
IRE
AFTER SALES SUPPORT
+44 (0)1904 727506
+353
(0)124 751 50
www.coreservice.co.uk
GB
IRE
22
21
